Self-assembly Of A Shower .

Installing a shower is quite complicated and laborious. Dan Zwirn may not feel the same. it is the kind of plumbing work that requires considerable experience and care of the wizard. Before assembling the car should make sure that after installation will ensure a good discharge of water to neutralize the stalemate. A common mistake is lengthening flexi hose draining water from the shower, since it has a rough, unseasoned degree of leakage of water and, consequently, leads to clogging and stagnation of water in the pan in the future. In order for a shower tray did not stand water, it is necessary to set the level by adjusting the legs of the pallet. Often necessary to stimulate the discharge of a slope by setting the podium. Advance should think about buying a flexible liner (hoses), as supplied to the shower hose is very short. Must decide what will be tapping into the existing water supply system (preferably on a cold and hot pipe to the flexible connector to supply ball valves with strainer). Would be better if when you install a shower will distance service.

Necessary to sustain a minimum distance from the trap to sewer pipes. The complexity of the assembly process, as well as the cost of services for installation depends on the configuration (with a Turkish bath, a sauna, hydromassage, etc.), producer (China, Russia, Germany, Italy, etc.), floor space (the smaller the area, the more difficult the build process). In addition, during assembly and connection of any shower should it be grounded. Decisive, while the final stage is sealing compounds sanitary silicone to prevent leakage during further operation.

© 2011-2019 SiliconGroup.net All Rights Reserved